5 Matching Annotations
  1. May 2019
    1. Cells growing in culture medium were harvested by trypsinization and washed twice with ice cold PBS. Cells were fixed by adding ice cold 70% ethanol and stored at 4°C. Before harvesting cells were washed twice with PBS and re-suspended in adequate amount of PBS containing Propidium Iodide (PI) to a final concentration of 50μg/ml and RNase to a final concentration of 10μg/ml. Thereby the cell suspension was incubated at 37°C for 30 minutes in dark. Analysis was done by running the samples in BD FACS Vantage System according to the standard procedures after calibration of instrument with Calibrite beads
    1. Vacuolar morphology of C. glabratacells was examinedby staining vacuoleswith FM4-64 (Molecular Probes, Invitrogen). FM4-64 is a lipophilic dye that exhibits long wavelength red fluorescence when boundto lipids. FM4-64 binds to the plasma membrane and follows the endocytic pathway to reach the vacuole(Vida and Emr, 1995).Log-phase,YPDmedium-grown cells were harvested and washed with 1X PBS. 1 ODcells were resuspendedin 50 μl YPDmedium containing 30 μM FM4-64 andincubated at 30 ̊C for 30-45 min. After incubation, cells were washed thricewith YPD mediumand resuspendedin 100 μl of the samemedium. Cells were observed under confocal laser scanning microscope(Zeiss LSM 510 Meta)with 63X objective lens,2.5X final zoom, pinhole set at 108 μm and emission filterset to LP 565nmto capture fluorescence image.Along with the fluorescenceimage, aphase contrastimage was alsocaptured for each sample
    1. QIAGEN QIAquick PCR purification kit containing buffers, spin columns and collection tubes wasused topurify DNA fragments from PCR andenzymatic digestion reactions as per the kit manufacturer’s instructions
    1. 2 bed volumes of methanol, and equilibrated with 5 bed volumes of distilled water. In order to reduce the water solubility of siderophore in the supernatant, it was acidified to pH 2 using concentarted HCl. This acidified supernatant was passsed through the column, and finally eluted with 160 ml methanol by collecting approximately 60 fractions (2 ml each) of the flow through. Siderophore assay was done on CAS plate with each collected fraction. Fraction that gave orangish-yellow halo for the siderophore on CAS plate, was combined together, dried in rotary evaporator and finally reconstituted in 1 ml methanol for further quantification using HPLC as described previously (Amin et al., 2009).For HPLC analysis, siderophore samples were filtered through filter membrane (porosity, 0.45 μ). Next, 10 μl sample was injected into Agilent C18 (4.6mm×250mm×5μm) column (gradient:(A=H2O/0.1%TFA), (B= CH3CN/0.1%TFA) 0-30% B in 10 min, 30-45% B in 15 min,45-0%B in 20 min at a flow rate of 1 ml/min). Similarly, standard vibrioferrin (siderophore produced by Xanthomonas) was also estimated through HPLC for comparison. Fe(III) bound vibrioferrin complex was prepared by incubating FeCl3.6H2O and apo-vibrioferrin for overnight. This complex was detected at300 nm (RT 10.998 min), whereas apo-vibrioferrin was detected at 220 nm at RT 10.988 min. The siderophore concentration in the samples were determined by peak area and calculated against the standard curves obtained from standard vibrioferrin. The siderophore from the test samples were detected at 300 nm, which confirms that majority of the vibrioferrin isolated from the culture was present in bound form
    2. Different Xanthomonas oryzaepv. oryzicola strains were grown overnight in PS medium at 28 °C and 200 rpm. 0.2% of the overnight grown culture was inoculated in the the fresh PS medium supplemented with 50 μM 2, 2’-dipyridyl, and grown till OD600 reached to 1. Cultures were centrifuged at 12,000 g for 50 min to get the cell free culture supernantant, which was collected into acid treated bottles. Excess exoplysaccharide was removed by centrifugation for longer time. Siderophore was initially isolated by column chromatography as described previously (Wright, 2010). Briefly, 220 g of XAD-16 resin was soaked overnight and packed into the column (2.4×30 cm), column was wa