21 Matching Annotations
- May 2019
-
shodhganga.inflibnet.ac.in shodhganga.inflibnet.ac.in
-
bands seen in the DNA size marker, were marked with a ball -point pen at the places where small holes had been pierced in the gel earlier ( see above ). Thus it was easy to monitor the size of the fragments showing hybridisation to the probe. The gel was then peeled off and the membrane w~shed in 6 X sse with gentle rocking for 10 minutes to wash away any residual agarose sticking to the membrane. After air drying at room temperature, the membrane was baked at so0e for two hours. The baked filter was stored at room temperature in a dessicator, if not used immediately. The dehydrated gel was restained in water containing 0.5 ug I ml ethidium bromide for 30 minutes and examined on a short wave UV transilluminator to check for the presence of any DNA fragments that escaped blotting. The absence of any residual bands indicated that the transfer was complete.
-
Restriction fragments of DNA resolved on agarose gel were transferred to nylon membrane ( GeneScreen or GeneScreen Plus by the capillary blotting procedure of Southern ( 1975 ) as described by Maniatis et al., ( 1982 ) . After the completion of electrophoresis, the gel was stained and photographed as described earlier. Position of the various bands obtained in the DNA size marker lane were marked by piercing small holes at the two ends of each band in the gel with a yellow tip. The gel was then denatured, neutralised and blotted essentially as described by Maniatis et al., ( 1982 ) . Locally available coarse absorbent paper was used to make the paper towels of the appropriate size. In case of genomic DNA from mammalian cells, the agarose gel was first treated with 0.25 M HCl for 10 minutes, followed by the rest of the procedure as mentioned above. The transfer buffer was 20 X SSPE in all cases. To prevent the absorption of fluid from the 3 MM paper under the gel directly to the blotting paper atop the nylon membrane, the gel was surrounded with polythene sheets to minimise the direct contact between the blotting paper and the 3 MM paper placed under the gel. The blotting was performed for 18 -24 hours. After the transfer was over, the paper towels and the 3 MM papers on top of the nylon filter were peeled off. The gel along with the attached membrane, was turned over and kept on a clean sheet of 3 MM paper with the gel side up. The position of the gel slots was marked with a ball -point pen. Also, the positions of the
-
southern blot.
-
Colony lifts were performed essentially as described by Maniatis et al. , 1982 ) . Recombinant colonies were grown 0/N at 37°C to have well separated colonies. The colonies were overlaid with 80 mm diameter nitrocellulose filter circles BA 85, S & S and after the filter became wet throughout, it was peeled off in a single, smooth motion, avoiding the smearing of the bacterial colonies. The plate was reincubated at 37°C for a few hours to regenerate the colonies. The colonies transferred to the filter were lysed to bind the liberated DNA to the nitrocellulose.
-
Colony lifts.
-
Transfer of DNA.
-
-
sg.inflibnet.ac.in sg.inflibnet.ac.in
-
incubations were carried out for I h at RT and each incubation was followed by three washings with PBS containing 0.1% Tween-20 (PBST). Post-blocking, the membranes were incubated with 1:1000 dilution ofMA-813 ascites (for detection ofr-bmZP1), MA-451 ascites (for detection of r-dZP3) or rabbit polyclonal anti-r-rG antibodies (for detection of r-rG), followed by an incubation with 1:5000 dilution of goat anti-mouse or goat anti-rabbit immunoglobulins conjugated to horseradish peroxidase (HRPO) (Pierce) respectively. The blots were developed with 0.6% (w/v) 4-chloro-1-naphthol in 50 mM PBS containing 25% methanol and 0.06% H202• The reaction was stopped by extensive washing with double distilled water
-
The cells (2 - 4 x 1 06) transfected with plasmid DNA were resuspended in minimum volume of 2X sample buffer (0.0625 M Tris, pH 6.8, 2% SDS, 10% glycerol, 5% P-mercaptoethanol, and 0.001% bromophenol blue). The samples were boiled for 10 min and resolved on a 0.1% SDS-1 0% PAGE (Laemmli, 1970). The expression of recombinant proteins was analyzed by Western Blot. The proteins were electrophoretically transferred to 0.45 J.lm nitrocellulose membrane 0/N at a constant current of 30 rnA (milliampere) in Tris-Giycine buffer (25 mM of Tris-HCl and 200 mM glycine) containing 20% methanol (Towbin et al., 1979). Post-transfer, the membranes were washed once with PBS and non-specific sites were blocked with 3% BSA in PBS for 90 min at RT. All the subsequent
-
Analysis of expressed recombinant protein by immunoblot
-
COS-I cells were seeded at a density of 2.5 x 105 cells per well in a 6-well tissue culture plate and transfected with plasmid DNA essentially as described above. After 48 h incubation, cells Were trypsinized and counted in a hemocytometer. Cells ( ~ 1 06) were washed twice with PBS and fixed with 0.4% paraformaldehyde in PBS followed by all washings and incubations with respective primary and secondary antibodies in presence of 0.1% Saponin. Antibody concentrations used were same as in indirect immunofluorescence assay. After the final wash, cells were resuspended in PBS and samples were run on an Elite ESP flow cytometer (Coulter Electronics, Hialeh, FL, USA) and data analyzed using WinMDI (version 2.8) software. Cells stained with just secondary antibody were used to account for the background fluorescence. Cells tranfected with VR 1020 vector and probed with primary antibody were used as negative control.
-
Analysis of mammalian cells, transfected in vitro with the plasmid DNA, by flow cytometry
-
To investigate if the expressed protein was membrane bound or cytosolic, cells were fixed in 3. 7% paraformaldehyde followed by all washings and incubations with primary and secondary antibodies either in presence or absence of 0.1% Saponin and processed for indirect immunofluorescence as described above.
-
Localization of the expressed recombinant protein in COS-1 cells
-
albumin (BSA) in PBS for 2 hat 4°C. For detection of r-bmZPI, a murine monoclonal antibody (MAb), MA-813, generated against E. coli expressed r-bmZP1 (Govind et al., 2000), was used as the primary antibody. The cells were incubated with 1 :500 dilution of MA-813 ascites fluid for 2 hat 4°C. Cells were washed 5 times with PBS and incubated for 1 h with a 1:800 dilution of goat anti-mouse Ig-fluorescein isothiocyanate (FITC) conjugate (Sigma) at 4°C. After washing with PBS, coverslips with the cells were mounted in glycerol : PBS (9 : 1 ), and examined under an Optiphot fluorescent microscope (Nikon, Chiyoda-Ku, Tokyo, Japan). For detecting r-dZP3, MAb, MA-451 (1 :500 dilution of ascites fluid), generated against porcine ZP3f3 (a homologue of dZP3) and immunlogically cross-reactive with dZP3 (Santhanam et al., 1998) was used. For detecting r-rG, rabbit polyclonal antibodies (1:1000 dilution) against E. coli expressed r-rG, was used as primary antibody. The polyclonal antibody was provided by Dr. Sangeeta Choudhury, Project Associate, Gamete Antigen Laboratory, National Institute of Immunology, New Delhi. Goat anti-mouse immunoglobulins-FITC conjugate (1 :800) and goat anti-rabbit immunoglobulins-FITC conjugate (1 :2000; Pierce) were used for detecting anti-dZP3 and anti-rG antibodies respectively
-
Initial standardization of transfection conditions was done using VRbmZPl plasmid DNA and COS-I mammalian cell line. In brief, cells were cultured in T-25 tissue culture flasks in Dulbecco's Modified Eagle's Medium (DMEM) supplemented with 10% fetal calf serum (FCS) at 37°C with 5% C02. For subculturing, cells were trypsinized (0.5% trypsin + 0.2% EDTA in DMEM without FCS), centrifuged at 250 X g for 10 min, resuspended in DMEM supplemented with 10% FCS and aliquoted into T-25 flasks. For transfection, cells were seeded on coverslips in a 24-well tissue culture plate at a density of 5x 104 cells/well, a day prior to transfection. To standardize in vitro transfection conditions for optimum expression of bmZP1, varying amount of plasmid DNA was mixed with lipofectamine in DMEM devoid ofFCS (final reaction volume 200 f.!l) and incubated at RT for 45 min. The cells on the coverslips were washed twice with plain DMEM devoid of FCS. DNA-Iipofectamine complex was added dropwise to the cells and the plate incubated for 8 h at 3 7°C in humidified atmosphere of 5% C02• Subsequently, 1 ml of DMEM containing 10% FCS was added per well and cells allowed to grow for 48 h. After incubation, cells were processed for visualization of r-bmZPl by indirect immunofluorescence assay. Cells were washed twice with phosphate buffer saline (PBS; 50 mM Phosphate and 150 mM NaCI, pH 7.4), fixed in chilled methanol (-20°C) for 3 min and blocked with 3% bovine serum
-
Detection of the expressed recombinant protein following i11 vitro transfection of mammalian cells with the plasmid DNA.
-
6000 X g for 15 min at 4°C. Plasmid DNA was purified from the pellet using QIAGEN DNA purification kit according to the manufacturer's instructions. The purified plasmid DNA (1.5 -2.0 mg/ml) was dissolved in autoclaved double distilled water and stored in aliquots (500 f.!l each) at -20°C until further use.
-
A single colony of the respective clones was picked up from a freshly streaked LB + Kan (50 f.!g/ml) plate, inoculated into 5 ml of LB + Kan medium and incubated for 8 hat 37°C with vigorous shaking (-250 rpm). Subsequently, 500 fll of this primary culture was inoculated into 500 ml LB+ Kan and grown at 37°C 0/N. The culture was centrifuged at
-
Purification of plasmid DNA in large amount
-
N-VITRO TRANSFECTION OF MAMMALIAN CELLS WITH V ARlO US PLASMID DNA CONSTRUCTS AND CHARACTERIZATION OF EXPRESSED RECOMBINANT PROTEINS
Tags
- Method-1-Method-11-Method-2
- Method-1-Method-11
- Method-1-Method-11-Method-5
- Method-1-Method-11-Method-3
- Method-1-Method-11-Method-1
- Method-1-Method-11-Method-4-detail
- Method-1-Method-11-Method-2-detail
- Method-1-Method-11-Method-4
- Method-1-Method-11-Method-1-detail
- Method-1-Method-11-Method-5-detail
- Method-1-Method-11-Method-3-detail
Annotators
URL
-
-
sg.inflibnet.ac.in sg.inflibnet.ac.in
-
Identification of selected micro-organism
-