5 Matching Annotations
  1. May 2019
    1. smiFISH: The smiFISH protocol was performed as described by Tsanov et al., 2016with modifications for use in the Drosophila embryo. Briefly, a minimum of 50μl of embryos were transferred to Glass V-vials (Wheaton) and transitioned from 100% Methanol to PBT in 50% increments, followed by several 10min PBT washes. Subsequently, embryos were washed at 37°C in stellaris wash buffer(1x SSC (150 mM NaCl and Sodium Citrate at pH 7.0), 10% deionised formamide) pre-warmed to 37°C. Hybridisation was performed using 4uM of labelled probes mixtures, as described above, incubated in stellaris hybridisation buffer (1x SSC, 100mg dextran sulphate, 10% deionised formamide) for a minimum of 14 hours at 37°C. Following hybridisation excess probes are removed with washes in stellaris wash buffer, pre-warmed to 37°C and subsequently washed with PBT. During the pen-ultimate PBT wash DNA and the nuclear membrane were stained using 1:1000 of DAPI (5mg/ml) and 1:1000 of wheat germ agglutinin (WGA) conjugated to Alexa 555 (5mg/ml, ThermoFisher Scientific), respectively. Embryos were subsequently mounted with ProLong Gold AntiFade (ThermoScientific).Alkaline Phosphatase Immunostaining: For immunostaining, a minimum of 50μl of embryos were gradually transferred from methanol to PBT and washed in PBT for 30mins with repeated changes of PBT. Embryos were blocked for 2hrs in 10% BSA in PBT and subsequently washed in PBT. Following this, embryos were incubated with monoclonal mouse anti-Hindsight-IgG1 (1:20, DSHB) primary in 1% BSA in PBT overnight at 4°C. To remove excess antibody, embryos were washed for 2hrs in 1% BSA in PBT. Next, polyclonal goat anti-mouse-IgG (H+L) AP Conjugate (1:500, Promega) was added in 0.1% BSA in PBT and incubated for 2hrs at room temperature. This was followed by washes with PBT and staining solution (defined above). Following staining, washing and mounting was performed as above. Image Acquisition: Images from alkaline phosphatase staining were acquired on a Leica DMR. Fluorescent images were acquired using a Leica TCS SP5 AOBS inverted confocal. Whole embryos were viewed using a20x 0.70 HXC PL APO Lambda Blue Immersion objective and embryo sections viewed with a 63x 1.40 HCX PL APO Lambda Blue Oil objective, with a maximum of 3x confocal zoom. Additional confocal settings were as follows: pinhole diameter of 1 airy unit, 400Hz unidirectional scan speedwith all images collected at 1024 x 1024. Images were collected sequentially usingPMTdetectors with the following mirror detection settings:DAPI (420-470nm), Alexa 488 (490-525nm), Alexa 555 (570-620nm) and Alexa 647 (650-780nm). The respective fluorophores were detected using the blue diode (20%) and the following laser lines: 488nm (50%), 555nm (50%) and 633nm (40%). When acquiring 3D optical stacks the confocal software was used to determine the optimal number of Z sections based on a Z section depth of 1μm at 20x and 0.3μm at 63x. Only themaximumintensity projections of these 3D stacks are shown in the results
    2. fluorescently conjugated secondary antibodies, also at a ratio of 1:400. Secondaries used included: donkey anti-mouse-IgG-Alexa 488, donkey anti-sheep-IgG-Alexa 555 and donkey anti-rabbit-IgG-Alexa 647 (all from ThermoFisher Scientific). Following incubation, excess secondaries were removed with PBT washes over 2hrs, including a 40 min incubation with 1:1000 wash with DAPI (5mg/ml, ThermoFisher Scientific). Finally embryos were resuspended in ProLong Gold AntiFade (ThermoScientific) and mounted. smiFISH Probe Design: CustomsmiFISH probes were designed using the Biosearch Technologies Stellaris RNA FISH Probe Designer ver 4.2 (Biosearch Technologies, Inc., Petaluma, CA), (available online at www.biosearchtech.com/stellarisdesigner(last accessed: 18/05/2017)) against the Drosophila genome. Probes were designed with the following parameters; masking level of >=3, oligo length between 18bp to 22bp, a minimum of 2bp spacing between probes with a minimum of 24 probes per gene. Sequences complementary to the Y and Z flaps based onTsanov et al., 2016were added to the 5’ end of the probes. 250pmoles of labelled flap sequences were hybridised to 200pmoles of smiFISH probes in 1x NEB Buffer 3 (NEB) and incubated in a thermocycler at a final concentration of 4uM in the following conditions: 85°C for 3min, 65°C for 3min and 25°C for 5min.Details of target regions, number of probes and flap sequence are shown below in Table 2.2with details of fluorescent-labelled flap sequences shown in Table 2.3. Individual probe sequences for Ance, peb and ush are available in the following supplementary tables: Table S1.1, Table S1.2 and Table S1.3, respectively. ProbeProbe TargetTarget Region(s)FlapNumber of ProbesAnceExon 1;Intron 1;Exon 2chr2L:13905733-13906413;chr2L:13906591-13907163;chr2L:13907608-13907958Y48PebIntron 1;Intron 2chrX:4512107-4513998;chrX:4514915-4515168Z48UshIntron 3;Intron 4chr2L:524083-525382;chr2L:525516-535905Z48Table 2.2. | smiFISH target probes target regions, including: flap sequence and total number of probes per regionsFlapSequenceFluorophore (nm)YAATGCATGTCGACGAGGTCCGAGTGTAAAlexa 488ZCTTATAGGGCATGGATGCTAGAAGCTGGAlexa 647Table 2.3. | Fluorescently labelled Flap sequences complementary to probes flaps, including fluorophore for smiFISH
    3. GenePrimer DirectionSequence (5’-3’)Intronic or ExonicAnceForwardAAACAAGTCATTCGCTTTAGGGCIntronicReverseCGCATTTTCGGATGACTCTGGKek1ForwardGCAGATTCGCACGGATGAACIntronicReverseTTTGCGTGGCAAAATGTGCTNetForwardATTCACCCAATTCCAACGACExonicReverseGTGGCAATGGACGGTACGGATupForwardCGGGAAAAGCAGCCTTGGATIntronicReverseTAGCTACAGCGAGTGCGAAATable 2.1. | Primer sequences for FISH.Alkaline Phosphatase RNA In-situ Hybridisation: For in situ hybridisations, a minimum of 50μl of embryos were washed with 100% ethanol, transitioned to 100% methanol, and then to PBT (1x PBS, 0.1% Tween-80). Embryos were then transferred to hybridisation buffer (previously described) and incubated at 55°C for 1hr, followed by overnight incubation in 0.5-2μl of the RNA probe in 50μl of hybridisation buffer. Sequential washes were then performed with hybridisation buffer and PBT, after which the embryos were incubated overnight at 4°C with anti-Digoxigenin-AP Fab fragments (1:250, Roche), pre-absorbed prior use against fixed embryos, in 500μl PBT. Excess primary antibody was removed with sequential several PBT washes, followed by two 5min washes in staining buffer (100mM NaCl, 50mM MgCl2, 100mM Tris pH 9.5, 0.1% Tween 80). The antibody bound RNA probe was visualised using 0.27mg Nitro-Blue tetrazolium and 0.14mg 5-Bromo-4-Chloro-3-indolyphosphate in 400ul. Staining was stopped by washing with PBT, followed by repeated washes with 100% ethanol over 1hr. Lastly embryos are briefly treated with 100% xylenes prior being mounted in Permount mounting medium (bioPLUS).Fluorescent RNA In-situ Hybridisation: For FISH, a minimum of 50μl of embryos were transferred from 100% methanol to 100% ethanol, as above. Embryos were washed for 1hr in 90% xylenes with 10% ethanol, followed by ethanol washes until complete removal of xylenes. Subsequently, embryos were washed with methanol and underwent post-fixation for 25mins using PBT with 5% formaldehyde. Following this embryos were pre-hybridised using hybridisation buffer (previously described) for 1hr at 55°C. Hybridisation was performed in 100ul of hybridisation buffer overnight at 55°C with 2μl of denatured RNA probe. Excess probes were removed through washes with hybridisation buffer and PBT. Prior to addition of primary antibodies, embryos were blocked for 30mins in 1x Blocking Reagent in PBT (Western Blocking Reagent, Roche). For detection of labelled RNA probes, the following primary antibodies were used: mouse monoclonal anti-Biotin-IgG (1:400, Roche), sheep polyclonal anti-DIG-IgG (1:400, Roche), rabbit polyclonal anti-DNP-IgG (1:400, ThermoFisher Scientific). Primary detection was performed overnight at 4°C in 400μl of 1x Blocking Buffer in PBT. Following incubation, excess primaries were removed with PBT washes and embryo re-blocked with 1x Blocking Reagent for 30mins. Subsequently, embryos were incubated for 1hr 30mins at room temperatur
    4. Embryo Collection: Embryos were collected at 25°C on apple juice agar plates from cages withapproximately 5ml of well-fed young flies. Collections were performed every 2hrs with plates aged at 18°C or 25°C After Egg Laying (AEL), as appropriate, resulting in a pool of embryos between 2-4hrs (Stage 5 to 9), unless otherwise stated.After ageing, collected embryos were washed with 1x NaCl/Triton X (68nM NaCl, 0.03% (w/v) Triton X-100) and loosened from plates with a brush. Embryos were subsequently dechorionated in 50% bleach for 2min and thoroughly washed, alternating between dH20 and 1x NaCl/Triton X. For RNA In-situ hybridisations, embryos were fixed with 4.625% formaldehyde for 20mins with 50% heptane and Fixing Buffer (0.5x PBS, 25mM EGTA pH 8.0). Following fixation, embryos are devitellinised using methanol, transferred to 100% ethanol and stored at -20°C. For Immunostaining, overnight plates with a maximum 12hrs of ageing were collected and dechorionated as above. Fixing was performed for 12mins with 1.85% formaldehyde, 50% heptane, and Buffer B (4.5mM KPO4, 6.75mM NaCl, 20.25mM MgCl2, 4.5mM NaP). Embryos were devitellinised as previously described, but stored in 100% methanol at 4°C.RNA Probe Synthesis: RNA probes for RNA in-situ hybridisation were synthesized using gene specific primers, flanked by the T3 and T7 promoters to transcribe sense or anti-sense probes respectively, except for the AncecDNA probes. All probes were designed against approximately 1kb of the target RNA unless otherwise constrained by sequence or target limits. All primers used to generate RNA probes are described in Table 2.1, including intronic or exonic position of probes. Anti-sense probes for Ancewere derived from Ance cDNA cloned between T3 and T7 promoters within pBluescript KS plasmid. Template is produced through PCR of the plasmid template using primers against the T3 and T7 promoters. Approximately 1ug of DNA template was used to generate labelled anti-sense RNA in a transcription reaction. Probes were either labelled with Biotin, Digoxigenin (DIG) or Dinitrophenol (DNP) labelled UTP in a mix with other nucleotides. The transcription reaction was carried out for 2 hrs at 37°Cusing, 1x transcription buffer (0.06M MgCl2, 0.1M NaCl, 0.02M Spermidine-HCl, 0.4M Tris pH 7.5), 10 Units RNAse inhibitor (Roche), 20 Units T3/T7 polymerase (Roche), 1x nucleotide mix (10mM ATP, 10mM GTP, 10mM CTP, 6mM UTP and 4mM Biotin, DIG or DNP labelled UTP (Roche)) and dH2O. The probes were then hydrolysed in 1x carbonate buffer (60mM Na2CO3, 40mM NaHCO3, pH 10.2) and incubated for 5mins at 65°C. Following hydrolysis, the reaction was stopped by the addition of 40μl dH2O, 50μl STOP solution (0.2M NaAc, pH6.0) for 5min and precipitated overnight at -20°C with 2μg of tRNA in 0.1M LiCl, and 100% ethanol. The sample was then centrifuged for 20mins at 13,000g and the pellet resuspended in 150ul of hybridisationbuffer (50% formamide, 750mM NaCl, 75mM sodium citrate, 100μg/ml ssDNA, 50μg/ml heparin, 0.1% Tween-80).
    5. Expression analysis of Drosophila Embryos